radius arms

[mini50]

hello folks

the latest part of my mini restoration is to rebuild the radius arms i bought the rebuild kit and have installed the new bushings now i have to ream the bushings to suit the new shaft the size of the reamer is 13 16' the problem is i cant get the right size reamer so i took the radius arms to a percision engineering work shop but they had not got the the right size of reamer i do not want to install the new grease tube or new bearns until i get the bushings reamed dose anyone know were i can get the reamer to do this job

regards
mini50

[irlmin]

The reamer is a 'special' as it fits right through the arm when it 'cuts' the bush therefore ensuring a straight cut . We have the genuine one which we got many many years ago from an Austin main dealer that closed down , no problem doing it if you want to drop the arms to Cork . We have reconditioned hundreds of these throughout the years .
G

[mini50]

That would be great will have to get talking you again about my engine and gearbox rebuild